Technical information

installation

Clamp

Seal

Screws

Fitting the 5” Flue

(Ø 80 / 125 Horizontal/vertical)

Once the boiler has been positioned on the wall, it is necessary

to insert the Ø80/125 adaptor (Fig. 5) for both horizontal and

vertical ue runs into the boiler ue socket (not supplied with

ue kit - Part No 3318095).

Push the adaptor onto the boilers ue connection, grease the

seals then add extensions or elbows as required, secure the

adaptor, using the clamp and screws provided.

To t extensions or elbows it is rst necessary to ensure that the

lip seal is tted correctly into the inner ue, once veried, it is

simply necessary to push them together, no clamps are neces-

sary to secure the ue components.

Before proceeding to t the ue, ensure that the maximum

ue length has not been exceeded (See the tables) and that all

elbows and bends have been taken into consideration, the ma-

ximum ue length is 10 metres, for each additional 90° elbow 1

metre must be subtracted from the total ue length, and for each

45° 0.5 metres must be subtracted from the total ue length (the

height of the vertical adaptor and a 45° bend can be seen in Fig.6

and a 90° bend in Fig. 7).

Note: DO NOT cut the vertical ue kit.

180 mm

Fig. 4

Fig. 5

Fig. 6 Fig. 7