Alteas ONE Net User Manual

/ 7
USER’S MANUAL
Ignition procedure
Press the ON/OFF button on the control panel to switch on the boiler.
The display shows the initialisation procedure - indicated by the bar.
Once the procedure is completed, the display will visualise the
temperatures set for the central heating and domestic hot water circuits
(display configuration: boilerbase).
It’s also required to set the date, time and language - see the note
below.
Operating mode selection
Wi-Fi bo
Initializing.......
00/00/00
Press OK to enter Menu
00:00
42°
70°
1,5 bar
ATTENTION - Initial start-up
The rst time the display requires a few basic
settings.
First, select the language. Press the programming key b
to select the language, then press the OK button to
conrm.
Move on to setting the date and time. Press the
programming key b to make a selection, press the OK
button to conrm your selection. Press the programming
key b to set the value.
Press the OK button to conrm. Save the settings by
pressing OK.
Press the OK button to access the User’s Menu.
Press the programming key b to scroll through the menu
list and select a parameter, then press OK to conrm.
CAUTION!!
Some parameters are protected with an access code
(safety code) which protects the boiler settings from
unauthorised use.
The ignition of the burner will be signalled by the blue LED 11.
Operating mode selection
Use the MODE button 4 to select the desired operating mode.
Operating mode Display
Winter
heating + hot water production for
domestic use with set temperature
19/11/15
Press OK to enter Menu
09:49
42°
70°
19/11/15
Press OK to enter Menu
09:50
42°
1,5 bar
19/11/15
Press OK to enter Menu
09:49
70°
1,5 bar
1,5 bar
Summer
only hot water production for
domestic use with set temperature
19/11/15
Press OK to enter Menu
09:49
42°
70°
19/11/15
Press OK to enter Menu
09:50
42°
1,5 bar
19/11/15
Press OK to enter Menu
09:49
70°
1,5 bar
1,5 bar
20/11/15
C Heating active
09:57
40°
70°
1,5 bar
20/11/15
DHW active
09:57
42° 70°
1,5 bar
Domestic hot water temperature adjustement
It is possible to set the temperature of the domestic hot water by
pressing the buttons 3 a temperature may be obtained which varies
from 36°C to 60°C. The value set previously will ash on the display.
Adjusting the heating
It is possible to set the temperature of the heating water by pressing
the buttons 9 +/-.
The temperature that may be obtained which varies from 40°C to 82°C.
The value set previously will ash on the display.