User guide

Telephone Router Setting User Guide
Aristel Networks Pty Ltd 4x4 PABX/Router User Guide and Setting Tool Programming Rev 3.6
12
5. System Programming by a phone
- Case Study 1
Out of the box Aristel PABX/Router has the following main default capabilities.
1. Line 1 rings at Tele 1 only (That is extension 11 only)
2. Line 2 rings at Tele 2 only
3. Line 3 rings at Tele 3 only
4. Line 4 rings at Tele 4 only.
5. All 4 lines are activated.
6. Out going calls can take up any one trunk, selected in a cyclic order.
7. Call transfer, call pick up etc. work as described earlier.
The system sometimes, needs to be programmed to suit the local
requirements.
It is very easy to program the system using a Window based Setting Tool
software.
However, a simple programming can be carried out through a telephone
extension using the command table.
5.1 Case Study 1
A customer wants the following implemented:
1. Only two trunk lines need to be activated.
2. Four telephones installed as Tele 11, Tele12, Tele13 and Tele 14.
3. Incoming calls on Line 1 need to ring Tele 11 and Tele 14 at the same time.
4. Incoming calls on Line 2 need to ring Tele 13 only
5. Tele 13 is to have capability to Call Forward all incoming calls to his/her
Mobile phone or to another extension, Tele 12, whenever desired.
6. Outgoing calls should pass through either Line 1 or Line 2.