User guide

Telephone Router Setting User Guide
Aristel Networks Pty Ltd 4x4 PABX/Router User Guide and Setting Tool Programming Rev 3.6
11
24
71N#
Turn On extension N hot line function
25
72TT#
Hot Line Delay Time (TT=01-99, Default: TT=04 sec.)
26
73Nxxxx…
+Hang Up
Setting hot line number for extension N (N=1-4). The
max length of the hot line number is 30. If the length less
than 30, it regard “Hang up” as end. If you input two “*” in
the hot number, the system regard two “*” as one unit
delay.
For example, input “73186**75786337898”, then hang
up. It set the first extension number as
“86**75786337898”. “**” is one unit delay.
Notice: After set a hot line number, the system had exited
from programming state. If you want to set other
command, you should enter into programming state with
command “*# *+Code Password” again.
27
82TT#
Charge Delay Time (TT=01-99, Default: TT=05 sec.)
28
900#
Initialize extension number as 11-14 ， and setting
“Extension Number Length” as 2
29
90L#
Setting “Extension Number Length” as L (L=1-4)
30
9Nxxxx#
Change the extension number of extension N (N=1-4) to
xxxx. It regard “#” as end. The length of the number must
match the parameter L (the command 90L#)
Note:
If you used the command “0000#”, you must use “ReadData” function in
“Main parameters” tab of PC Software to read the default data from the
device. And then you should use “Send Data to Device” to set parameters.
At the end restart the device.