Specifications

                         USER MAUNAL 


10

 



Aristel Group
24
EG
5 System Program Setting
5.1 Enter the System Program Mode # * 10 

 [System Password]
All settings are available only under the system program mode and can be done by any
extension. To enter the system program mode:
(1) Off hook to hear the dial tone;
(2) Press # * 10, enter the System Password (5 digits);
(3) The system comes into the program mode while hearing the dial tone again;
(4) Operate the required setting. Hear the dial tone when setting is successful;
(5) Repeat Step (4) to continue other settings.
Note:
 The default system password is 00000; Please reset the system before commencing system
program for the first time.
 During the system programming, a dial tone indicates that the setting is successful and other
settings can be continued. However, if the setting failed, you will hear a busy tone, then
please “hook flash” or press the “Flash” Key to hear a dial tone and continue the settings.
 ** is to indicate all the extensions (*** for 3 digits extension number and **** for 4
digits);
The system provides up to 8 channels of CO line connections, among which 4 channels are
for GSM access and the other 4 channels are for analog trunk such as PSTN. Hereinafter
where the CO line No. is needed in the settings, 1 to 4 is to indicate the four GSM access
channels, 5 to 8 to indicate the four analog trunks and 9 to indicate all the CO lines. 
5.2 System Reset # * 20 

 [System Password]
This setting is to restore all the setting values to factory default.
(1) Under the system program mode, Press # * 20, enter the System Password (5-digits);
(2) Dial tone is heard to confirm successful reset after a pause of about three seconds.
5.3 CO line connection setting #*11 

 [CO Line No.] 

 [0/1]
When one channel of CO lines is not used, it must be set as not connected to keep the user
away from the access to a non-existent CO line.
(1) Under the system program mode, Press # * 11, CO Line No., then press M;
M = 0, not connected.
M = 1, connected;
(2) Hear dial tone while setting successfully.
Note: The default setting for all the CO lines is as connected;