User guide
Table Of Contents
- Aristel networks
- Dial pad symbols
- A: Key Telephone Layout and Parts List
- B: Key Telephone Station Operation
- 01. Automatic Answer
- External Call
- Other Calls
- 02. Baby Listening
- Cancel Baby Listening
- 03. Background Music Listening
- Cancel Background Music Listening
- 04. Call Forward
- NOTE! + can be replaced by pressing in all Modes.
- To Cancel All Call Forward Modes
- Call Forward All
- + + + + destination station number.
- Call Forward No Answer
- Call Follow Me
- Call Forward to External Number
- 05. Call Signal
- 06. Call Split
- 07. Call Transfer
- Announced Transfer
- Unannounced Transfer (Camp On)
- Quick Transfer by DSS key
- Quick Transfer by Page key
- 08. Call Waiting
- Answer Call Waiting
- Busy C.O. line queuing
- 09. Conference
- Combined External/Internal Conference
- External Conference
- Internal Conference
- 10. Do Not Disturb
- Set Do Not Disturb
- Reset Do Not Disturb
- 11. Door Phone
- Call Door Phone
- 12. Environment Monitoring
- 13. Fire Alarm Off (Console Only)
- 14. Forced Account Codes
- 15. Handsfree / Handset Switching
- Handset to Handsfree operation
- Handsfree to Handset operation
- 16. Handsfree Operation
- 17. Headset Operation
- Programming
- Enable Headset mode
- Disable Headset mode
- Answer a Call in Headset mode
- Disconnect from a Call in Headset mode
- 18. Hold Calls
- Normal Hold
- Exclusive Hold
- Retrieve External Call from Normal Hold
- 19. Individual / Own station Alarms / Date & Time
- 20. Internal Calls
- 21. Lock / Unlock Telephone.
- 22. Lock / Unlock RS232 (SMDR) port.
- 23. Macro Key Assignment.
40. Toll Code
Step 1.
+ any C.O. line to be used for the call.
Step 2.
+ +
Step 3.
enter the Toll Password (Max. 8 digits) +
Step 4.
the required Telephone number
Step 5.
+
Note: If zone 253 is enabled, the full Toll Code used will be printed in the SMDR output.
41. Voice Message Recording/Playback (Console Only)
Message Recording
Step 1.
+ + +
Step 2. The LCD will display the following instructions:-
= R = Record message(s) = P = Playback the message(s)
= N = Go to the next message = B = Go to previous message
Step 3.
the system will immediately commence recording the message.
Step 4. When the recording of the message has finished,
this marks the end of the
message and the system will immediately commence recording the next message.
Step 5. Repeat Step 4 for each message except for the last message.
Step 6. At the end of recording the last message, hangup the handset using your fingers. (this
gives a “clean” sounding end to the message)
Note: The messages MUST be recorded in the sequence as programmed. IF THE
SEQUENCE IS ALTERED, THE SYSTEM WILL MALFUNCTION.
System Administrator’s Manual Issued December 2004 Page 29