Installation Guide

Arista – Bathroom Accessories

New Quick-Fit Mounting Design

Congratulations for purchasing Arista New Quick-Fit Mounting design quality

Bathroom Accessories. We thank you for purchase of our Towel Bar (either 18” or

24”), Towel Ring, Tissue Paper Holder and/or Robe Hook!

This is a general Installation Instruction Manual which will apply for the different

Arista New Quick-Fit Mounting design bath accessory products you have purchased.

Following the below step-by-step instructions will guide you through the easy

installation in minutes!

EASY INSTALLATION – By just Clicking in a Second !

(Easy-to-Use Universal Mounting Template & Mounting Hardware Included)

A Universal Mounting Template sheet is provided, which has the marked positions for the Towel Bar,

Towel Ring, Tissue Paper Holder (with either Single Bracket or 2-Bracket design), Robe Hook,

whichever will apply.

Fig.1

1. According to the different products you are going to install, check the corresponding mounting

length needed as indicated on the Universal Mounting Template sheet.

Tape the required part of the template sheet on to the wall at the desired location, Fig. 1. Check

the “Center-Line” on the template is level on the wall. Place the Quick-Mount design mounting

plate(s), Fig. 3, vertically at the corresponding location(s) along the Center-Line on the template,

with the upper & lower screw holes evenly distributed above & below the Center-Line and with

the spring-pin on the lower side. Then, mark the screw locations along the vertical line on the

template, through the upper & lower holes at the mounting plate.

2. Take away the mounting plate after marking is done. Start to drill holes at the marked screw

locations, Fig.2.

On ceramic tiles wall, always try to locate the mounting hole location(s) on the grout line. If

un-avoidably mounting on tile surface is needed, use masking tape to facilitate easier marking

and to prevent sliding during drilling. Use 1/4” diameter carbide drill bit for drilling the holes.

3. Push the plastic anchors provided into the holes until flush with the wall. Then, screw the

mounting plates to the wall with the screws provided, Fig. 3. Do not over-tighten the screws.

Note : Molly or toggle bolts may be required for hollow wall. (not included)

PAGE 1
the “Center-Line” on the template is level on the wall. Place the Quick-Mount design mounting plate(s), Fig. 3, vertically at the corresponding location(s) along the Center-Line on the template, Arista – Bathroom Accessories with the upper & lower screw holes evenly distributed above & below the Center-Line and with New Quick-Fit Mounting Design the spring-pin on the lower side.
PAGE 2
4. At last, mount the product by just clipping the product’s Bracket over the mounting plate with Limited Lifetime Warranty detail as below. No further screwing is needed. WTI, Inc. /Arista Branded product warrants that its products are free from manufacturing defects and comply ~ Firstly, orientate the bracket with the pin hole on the bottom side. Match the bottom pin with specifications for such products.