User Guide

66 | AF-9400PV2R Users’ Manual
5.1.3 Manual Search ( )
After antenna setting, you can search channel(s) from the selected satellite if you know the
transponder information.
①
!
Move to the Search Channel menu using the “
◀▶
” button, and press the “OK” button.
②
Move to the Manual Search sub-menu using the “
▲▼
” button, and press the “OK” button.
!
③
Enter your password using the
“
0~9
”
buttons. The default password is 0000.
z
Tuner :
1, 2,/Loop/ twin
z
Frequency, symbol rate :
You can edit
the value using the “0~9” button.
z
Polarization:
Vertical, Horizontal
z
FEC:
Auto, 1/2, 2/3, 3/4, 5/6, 7/8
z
Network Search & FTA only:
Yes, No
1. Select the desired satellite using the “
◀▶
” button.
2. Show the tuner value according to the tuner type at the Search Channel-System setup menu. (1,
2 for T1/T2, Loop for Loop, or Twin for Twin)
: If you select ‘T1/T2’ at the Search Channel-System setup menu, you should set
the antenna setting of ‘1’ and ‘2’ separately. Select ‘1’ to search the channels for ‘T1’, and then
select ‘2’ to search the channels for ‘T2’.
3. Enter the Frequency & Symbol Rate value using the “0~9” button.
4. Select the Polarization, FEC, Network Search, and FTA Only value using the “
◀▶
” button.
5. When you complete the setting, press the “Red” button to search the channel.
6. When Channel Search is finished, the confirmation message will appear. Move cursor to the
“OK” button and press the “OK” button to save the changes.