User Guide

64 | AF-9400PV2R Users’ Manual
: If you select ‘T1/T2’ at the Search Channel-System setup menu, you should set the
antenna setting of ‘1’ and ‘2’ separately. Select ‘1’ to search the channels for ‘T1’,
and then select ‘2’ to search the channels for ‘T2’.
3. Set the transponder value for the satellite using the “
◀▶
” button.
4. Set the LNB power and frequency type using the “
◀▶
” button.
: When using Universal LNB, select Universal for LNB type (9750/10600 (MHz)).
Also, if you select Universal, 22kHz tone value is controlled automatically.
5. Select 22kHz Tone using the “
◀▶
” button. When using 22kHz tone switch, select ‘On’.
Otherwise, select ‘Off’.
6. Select the DiSEqC value using the “
◀▶
” button.
7. When you complete the setting, press the “Red” button to set the search mode.
8. Select the desired item using the “OK” button and press the “Red” button to search the channels.
9. When completing Channel Search, the following message will appear. Move cursor to the “OK”
button and press the “OK” button to save the changes.