User Guide

Ch3. Basic Settings | 31
3.5 Antenna Setting ( )
You can set the antenna's properties to watch the program. This setting is provided to the only TV1
viewer.
: If TV1 viewer selects Search to ‘Enable’ at the Setup-TV2 Control menu, TV2 viewer
can also set the antenna setting. Refer to Chapter 5.3.8 TV2 Control for more
information.
1. Select the Satellite name using the “
◀▶
” button.
2. Show the tuner value according to the tuner type at the previous step(1, 2/Loop/Twin).
: If you select ‘T1/T2’ at the previous step, you should set the antenna setting of ‘1’
and ‘2’ separately. Select ‘1’ to search the channels for ‘T1’, and then select ‘2’ to
search the channels for ‘T2’.
3.
Set the transponder value for the satellite using the “
◀▶
” button.
4. Set the LNB power and frequency type using the “
◀▶
” button.
: When using Universal LNB, select Universal for LNB type (9750/10600 (MHz)).
Also, if you select Universal, 22kHz tone value is controlled automatically.
5. Select 22kHz Tone using the “
◀▶
” button. When using 22kHz tone switch, select ‘On’.
Otherwise, select ‘Off’.
6. Select the DiSEqC value using the “
◀▶
” button.
7. When you complete the setting, press the “Red” button to set the search mode.