User Guide

30 | AF-9400PV2R Users’ Manual
3.4 System Setup
You can set the antenna’s properties such as system, tuner, longitude, latitude, and etc.
z
System:
Fixed, DiSEqC, USALs
z
Tuner:
T1/T2, Loop, Twin
z
Longitude, Latitude :
You can enter the
value using the “0~9” button.
z
Move :
Stop, East, West
z
Limit Setting :
Disable, Enable, Set East,
Set West
1. Select the system value using the “
◀▶
” button. The default value is ‘Fixed’.
2. Select the tuner according to the connection type using the “
◀▶
” button. (T1/T2, Loop, or Twin)
z ‘T1/T2’ means two tuners are working separately. ‘T1’ means the tuner is connected to LNB1 IN
and ‘T2’ means the other tuner is connected to LNB2 IN.
z ‘Loop’ means the tuners are connected using the loop-through cable from LNB 1 OUT to LNB
2 IN. If you have only one antenna cable, it’s good for you to select ‘Loop’.
z If you use twin LNB, you can select ‘Twin’.
3. When you complete the settings, press the “Red” button to move to the next step.
4. Move cursor to the “OK” button and press the “OK” button to save the settings.