User Guide

Ch2. Connections | 23
2.2 Connecting a Dish
AF-9400PV2R provides three antenna modes(Loop, twin, T1/T2). Refer to Chapter 3.4 System
Setup for detailed information.
Case1) One Antenna and a loop-through cable
:
If you connect one antenna cable to
the LNB1 IN and connect the LNB1 Out to the LNB2 IN with a loop-through cable.
When the channel of LNB1 is recorded, you can switch and view channels which have the same
polarity or transponder with the recorded channel.
Case2) Different Two Antennas
:
LNB 1 IN and LNB 2 IN have different signal sources.
Even during recording, you can freely switch channels regardless of polarity or transponder.
1. One Antenna and a loop-through cable
1) Connect the satellite antenna cable to the LNB1 IN.
2) Connect the LNB1 Out to the LNB2 IN with a loop-through cable.
3) Select ‘Loop’ in the antenna setting. Refer to Chapter 3.4 System Setup for detailed information.
2. Two Antennas
1) Connect the satellite antenna cable to the LNB1 IN.
2) Connect other satellite antenna cable to the LNB2 IN.
3) Set ‘T1/T2’ separately in the antenna setting. Refer to Chapter 3.4 System Setup for detailed
information.