User Guide

Ch2. Connections | 17
5) Function Switch Selection (A, B, C)
You will find slide switch on the bottom of receiver if you remove the plastic case. The positions A,
B, C are used to set the receiver to different remote controls. The factory setting is on position C
(Most of remote control use position C)
A: 56KHz (a few special remote)
B: 38KHz (most of remote controls)
C: sensitivity lower (external interference etc)
6) erference
To determine whether your extender is causing the interference. If your receiver does not function
properly, the two LEDs(A&B) will blink continuously or one LED will blink even without you using a
remote control. IF THIS OCCURS PLEASE SEE BELOW.
1. Move your extender away from the receiver and check + realign.
2. Connect your extender to an outlet on a different electrical circuit from the receiver
3. Reduce the antenna length.
4. Select position “C” of slide switch on the back of the receiver.
Please remove the plastic cover first.
5. If you cannot eliminate the interference, please contact your dealer.
7) echarging Battery
Your RF transmitter is installed with small recharging battery (2/3 AAA size), and the performance
of the extender deteriorates (the LEDs do not blink when you press the remote control), you need
to recharge (replace) the battery.
1. Remove the RF transmitter from your remote control and take rechargeable battery out.
2. Find the recharging pocket on the bottom of receiver. There should be an extra battery, fully
charged already in the pocket.