User manual

2.7 Cables & Connectors

2.7.1 Front Panel Connectors

Power LED:

This 3-pin connector attaches to the power LED.

HDD Activity LED:

This 2-pin connector attaches to the LED of the hard disk. The LED lights up

when HDD is active.

Power Switch:

This 2-pin connector attaches to the power button of the system.

Reset Switch:

This 2-pin connector attaches to the case-mounted reset switch for rebooting your

computer without turning on/off your power switch.

ACPI Sleep Switch: This 2-pin connector connects to the switch that can take the system into standby

mode when pressed.

NMI to CPU Switch: This 1-pin connector connects to the switch that send Non-Maskable Interrupt to

the CPU. User can customize the button to perform a particular function.

5 VSB: This connector provides the user with power to any extra devices that uses 5 volt

power.

Cooling Fault LED: This connector connects to the LED that lights up when a problem arises with

cooling system.

System Fault LED: This connector connects to the LED that lights up when a problem arises with the

system.

NIC#1 Activity LED: This connector connects to the LED that lights up when there is activity on Gbe

SMBus SDA: A private bus to BMC chip for serial data, for use with BMC only.

SMBus SCL: A private bus to BMC chip for serial clock, for use with BMC only.

Chassis Intrusion: This connects to the mechanical switch that indicates whether the chassis had

been opened. User can activate it if desired.

NIC#2 Activity LED: This connector connects to the LED that lights up when there is activity on Gbe