User manual

3.5.3 Integrated Peripherals Sub Menu
The Integrated Peripherals Sub Menu looks like the following:
PhoenixBIOS Setup Utility
Advanced
Integrated Peripherals
Item Specific Help
►Keyboard Configuration
Legacy USB Support: [Enabled]
Floppy disk controller: [Enabled]
Serial port A: [Enabled]
Base I/O address: [3F8/IRQ 4]
Serial port B: [Enabled]
Base I/O address: [2F8/IRQ 3]
Onboard SCSI (LSI53C1020A) [Enabled]
Onboard GLAN OPROM Scan: [Enabled]
Enables 2
nd
Logical
rocessor.
P
This is applicable only
for Hyper-Threading
supported Operating
System.
Check with OS
vendor for detail.
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit ←→Select Menu Enter Select►Sub-Menu F10 Save and Exit
The following table shows the items that you can customize on the Integrated Peripherals sub-menu page:
Item Options Description
Legacy USB Support Disabled
Enabled
Enable or Disable support for
USB Keyboard and Mice.
(Enable for use with a non-USB
aware Operating System such as
DOS or UNIX)
Floppy disk controller Disabled
Enabled
Auto
Enable or disable onboard
legacy floppy diskette
controller.
NOTE:
If disable is chosen please set
main menu legacy diskettes to
disabled.
If not done and an add-in
removable device is used, it will
not be assigned drive number 0
(or a:)
Serial port A/B Disabled
Enabled
Auto
Configure serial port A/B using
options:
[Disabled]
No Configuration
[Enabled]
User configuration
[Auto]
BIOS or OS chooses
configuration
46