Installation Guide

ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
877.287.8 634
•
C3696-INS-RA
•
PAGE 2
Step 1
Place the C-shaped mounting plates into
the track on the running board.
Note: The number of mounting brackets
may vary based on application. Use one
C-shaped mounting plate per bracket.
Step 2
Carefully place the running board
onto the mounting brackets.
Slide the C-shaped mounting plates along
the track to align with the mounting
brackets on the vehicle.
Step 3
Secure the running board to the mounting
brackets using two M8 hex bolts, two
lock washers and two flat washers.
At this time, adjust the running board
to the desired location.
With the running board in position, it is
recommended to tighten all brackets to the
vehicle first, followed by the running board
connections.
For recommended torque specifications,
refer to the table on page 1.
Step 4
Repeat all steps for the
passenger side of the vehicle.
Congratulations on the installation of your
new ARIES RidgeStep
™
running boards.
With the running boards installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on the
first page of this installation manual.
Representative Image