INSTALLATION INSTRUCTIONS 2005-2013 TACOMA GRIL GUARD PART# 2054 / 2054-2 (Skid Plate Must be removed- If Equipped) PARTS LIST: 1 1 1 1 1 2 2 6 16 8 Grille Guard Driver/Left Mounting Bracket Passenger/Right Mounting Bracket Driver/Left Top Bracket Passenger/Right Top Bracket 10mm x 30mm “T” Bolts 12mm x 120mm Hex Bolts 12mm x 35mm Hex Bolts 12mm x 32mm OD x 3mm Flat Washers 12mm Hex Nut 8 2 4 4 4 2 2 2 1 12mm lock washers 10mm x 30mm Button Head Bolts 10mm x 27mm OD x 3mm Large Flat Washers 10mm Hex Nut
PROCEDURE: 1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. DO NOT ATTEMPT INSTALLATION ALONE; PERSONAL INJURY OR DAMAGE TO THE TRUCK MAY RESULT. 2.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. For black finishes: Mild soap may be used to clean the Grille Guard. Fig 1 LED light attached to support flange. NOTE: LED Manufactures will have similar but different mounting styles or brackets, once you determine you mounting options attach it to the support flange as seen.
Fig 4 Driver Side Installation Pictured Existing (3) threaded studs 12mm x 120 Hex Bolts 12mm Flat Washer 12mm Flat Washer 12mm Nylon Lock Nut (3) 12mm x 35mm Hex Bolts (6) 12mm Flat Washers (3) 12mm Nylon Lock Nuts Factory hex nuts bolting driver side Frame Bracket to end of frame channel (3) 12mm x 35mm Hex Bolts (6) 12mm Flat Washers (3) 12mm Nylon Lock Nuts Fig 5 (1)12mm x 120 mm Hex Bolts (2)12mm Flat Washers (1)12mm Nylon Lock Nut Fig 6 Front Front Page 4 of 5 09/25/13
NOTE: It is not necessary but it may be easier to bolt the Top Brackets to the horizontal cross member in front of the radiator after the factory skid plate has been removed Fig 7 Insert T-Bolt Plate from behind and through hole in bottom of cross member Fig 8 Front Bottom of cross member in front of radiator.
INSTALLATION MANUAL Parts List Level of Difficulty 1 LED light bar, 10" Easy 1 Mounting bracket, left 1 Mounting bracket, right 1 Wiring harness 2 Security screw, M6 - 1.0 x 25mm 2 Rubber spacer, M6 2 Flat washer, M6 2 Hex head cap screw, M8 - 1.25 x 18mm 2 Flat washer, M8 2 Nylock nut, M8 -1.
Basic Dimensions 33.5 31.9 25° 2.6 0.6 1.6 A A 1.3 1.4 0.3 1.4 (30.9) Mounting Illustration ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 1501264-INS-RA • PAGE 2 0.
