Installation Guide

GRILLE GUARD
07-14 TOYOTA TUNDRA, 08-14 SEQUOIA
Page 1 of 8 5/19/14 Rev1 (DP)
PARTS LIST:
1
Grille Guard
2
10mm Cam Lever Quick Release Bolts with
Special Pivot Washer
1
Driver/left Frame Mounting Bracket
4
10mm x 24mm OD x 2.2mm Flat Washers
1
Passenger/right Frame Mounting Bracket
2
10-1.5mm Nylon Lock Nuts
1
Driver/left Top Frame Bracket
4
8-1.25mm x 25mm Hex Bolts
1
Passenger/right Top Frame Bracket
4
8mm Lock Washers
1
Driver/left Top Bracket
4
8mm x 22mm OD x 2mm Flat Washers
1
Passenger/right Top Bracket
4
12mm Plastic Washers
4
12-1.75mm x 35mm Hex Bolts
4
10mm Plastic Washers
4
12mm x 32mm OD x 3mm Flat Washers
2
600mm x 50mm x 1.0mm Adhesive Foam Strips
4
12mm Lock Washers
IMPORTANT: The Grille Guard is designed to tilt forward to clear the attached grille on 2007-13 Tundra,
08-14 Sequoia models. To tilt the Grille Guard, the Quick Release Bolts on the Top Brackets must be
released and the upper bolts on both Mounting Brackets may need to be loosened slightly. Make sure
that all hardware is fully tightened after closing the hood. Carefully read Page 8, "Opening and Closing
of Hood," before installing the Grille Guard.
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. MAY INTERFERE WITH FRONT MOUNTED
SENSORS. NOT RECOMMENDED FOR VEHICLES WITH OPTIONAL "ACTIVE" LASER GUIDED
CRUISE CONTROL SYSTEMS. CUTTING MAY BE REQUIRED.
2. Start installation at the front of the vehicle.
07-13 Tundra, 08-14 Sequoia models: Open the hood. Top Brackets can either be installed from
above or below front bumper depending on model, accessories and year, (Figure 1A & 1B).
2014 Tundra models: Top Brackets must be installed from below front bumper, (Figure 1B).
3. Locate the passenger side bumper bracket bolted to the end of the frame through the gap between the
front bumper and the radiator or from below the bumper above the tow hook, (Figure 1B). If installing
(4) 10mm Plastic
Washers
Driver/Left Top
Bracket
Passenger/Right
Top Bracket
Driver/Left Frame
Mounting Bracket
Passenger/Right Frame
Mounting Bracket
(2) 10mm Quick Release
Bolts with Pivot Washers
(4) 10mm Flat Washers
(2) 10mm Nylon Lock Nuts
Passenger/Right
Top Frame Bracket
Driver/Left Top
Frame Bracket
(4) 12mm Plastic Washers