Owners manual

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 2055152-INS-RA • PAGE 2
Step 1
Starting on the driver side, locate
the three mounting locations
underneath the vehicle.
Step 2
Starting at the front driver-side mounting
location, remove the two hole plugs.
Place the driver-side front mounting
bracket onto the vehicle and secure
with two silver M8 hex bolts, lock
washers and flat washers.
Snug the hardware,
but do not fully tighten.
Step 3
Repeat step 2 to install the middle
and rear mounting brackets.
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
For chrome powder coat, polish may be used to clear small scratches
and scuffs on the finish. Mild soap may be used also to clean the product.
For black finishes, mild soap may be used to clean the product.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Torque Specifications
METRIC
M6 bolt 3 ft.-lbs.
M8 bolt 7 ft.-lbs.
M10 bolt 16 ft.-lbs.
M12 bolt 28 ft.-lbs.
SAE
1/4" bolt 3 ft.-lbs.
5/16" bolt 7 ft.-lbs.
3/8" bolt 16 ft.-lbs.
7/16" bolt 20 ft.-lbs.
1/2" bolt 28 ft.-lbs.