Installation Guide

PAGE 1 • 15600FB-INS-RB • 877.287.8634 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Product Image
Figure 1
Notes and Maintenance
Before you begin installation,
read all instructions thoroughly.
Never exceed the vehicle, winch
or fairlead brackets rated capacities.
Refer to the winch and fairlead
manufacturers operating instructions
and warnings before using the
installed product.
Improper use or installation
may result in failure.
Level of Difficulty
Easy
Parts List
1 Fairlead bracket, 15600FB
Installation Instructions
1 Position the 15600FB fairlead
adapter over the holes on your
ARIES modular front bumper.
2 Loosely assemble a compatible
roller fairlead to the front mounting
holes in the adapter as shown.
The bottom mounting locations
are recommended for most
bottom wound winches.
Use the mounting hardware
supplied by the roller fairlead
manufacturer with the bolts
heads installed from the winch
side of the adapter.
3 With the fairlead loosely installed,
place a compatible winch on top
and align the mounting holes with
the bracket and bumper below it.
Use the winch manufacturers
mounting hardware and
installation instructions to
attached the winch to the center
bumper section.
4 With the winch in position, torque
all hardware to the manufacturers
recommended torque.
5 Thread the winch cable through
the opening in the roller fairlead
and attached the tow hook.
6 Congratulations on the
installation of your brand new
ARIES winch plate.
Scan
for helpful
install tips
INSTALLATION MANUAL 15600FB
Winch
15600FB
Roller fairlead -
10" center-to-center
mounting pattern
Fairlead mounting
hardware not supplied
(Follow fairlead mfg
mounting instructions)
Winch mounting
hardware not supplied
(Follow winch mfg
mounting instructions)