Product Manual

GB - 22
ADJUSTING THE UNIT TO TRACK
STRAIGHT
Check and adjust tire pressure. Increase
pressure on side unit tracks to. DO NOT
exceed maximum recommended tire
pressure (See Specifications on page 29).
If tire pressure adjustment does not solve
tracking problem, adjust the limiter bolts on
the stop bracket (Figure 15). Front bolts
adjust forward and rear bolts adjust reverse.
Lengthen the limiter bolt (move closer to
lever) on side which is too fast.
ADJUSTING THE HEIGHT OF THE
STEERING LEVER HANDLES
NOTE: Align handlebars by adjusting
eccentric spacer until the height of
handlebars are the same.
1. Remove mounting hardware and move
handlebar up or down until the steering
levers are at the appropriate height.
2. Install mounting hardware.
WARNING: Prior to adjusting the
tracking of the unit, shut OFF
engine, engage parking brake,
and remove the ignition key.
1. Tie-Rod Jam
Nut
2. Tie-Rod
3. Steering
Lever
4. Brake
Interlock
5. Hydrostatic
Transmission
Figure 14
OF3381
1
2
3
4
5
1
Figure 15
1. Limiter Bolt
2. Jam Nut
3. Steering
Lever
4. Stop
Bracket
1
2
3
1
4
2
Figure 16
OF4315
1. Handle
2. Eccentric
Spacer
3. Steering Lever
4. Mounting
Hardware
1
3
2
4