Operator`s manual

EN – 24
See Figure 37.
6. Disconnect lower traction drive cable from upper
traction drive cable.
7. Loosen, but DO NOT remove shoulder bolt retaining
cable pulley to cable pulley bracket.
8. Remove cable from cable pulley and remove cable
from unit.
Install Traction Drive Cable
1. Connect lower traction drive cable to upper traction
drive cable.
2. Feed cable end through hole in back cover.
3. Align cable with cable pulley and tighten shoulder bolt.
4. Install cable eyelet onto swing gate and secure with
flat steel washer and hairpin.
5. Reinstall bottom cover and secure with six hex bolts.
6. Reinstall wheels and secure with axle lock pins.
7. Return unit to operating position.
8. Adjust traction drive clutch. Refer to Operator’s
Manual for adjustment procedure.
9. Fill fuel tank and reconnect spark plug wire.
AXLE BUSHING REPLACEMENT
Remove Bushing
NOTICE: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Place unit in service position. See Service Position on
page 8.
4. Remove bottom cover. See Bottom Cover Removal on
page 9.
See Figure 38.
5. Remove flat steel washer from axle.
6. Remove hardware securing bushing to frame. If
replacing bushing on right side of frame, remove roll
pin from left side of axle and slide axle and spur gear
left to access hardware.
7. Remove bushing.
Figure 37
1. Upper Traction Drive Cable
2. Lower Traction Drive Cable
3. Cable Pulley
4. Back Cover
5. Shoulder Bolt
1
2
3
4
5
WARNING: AVOID INJURY. Before placing unit
in service position, close fuel valve and drain fuel
from tank and fuel system. See Draining Fuel
System on page 8. Make sure unit is secure and
will not tip.
Figure 38
1. Tapping Screw
2. Flat Steel Washer
3. Axle
4. Roll Pin
5. Bushing
1
2
5
4
3