Operator`s manual

EN – 23
Install Engine
1. Lower engine onto frame so weld screws in frame
insert through mounting holes in engine base.
2. Reinstall four locking washers over weld screws and
secure with hex nuts. Torque to 8.8 – 13.2 lbf-ft
(11.9 – 17.9 N•m).
3. Align traction sheave key with crankshaft keyway and
reinstall traction sheave onto crankshaft.
4. Reinstall traction drive belt onto traction sheave.
5. Reinstall idler spring to traction drive idler and frame.
6. Align attachment sheave key with crankshaft keyway
and reinstall attachment sheave onto crankshaft.
Secure with locking washer and hex bolt and tighten
hardware.
7. Reinstall attachment drive belt onto attachment
sheave.
8. Reinstall belt finger and secure with two flat steel
washers, two locking washers and two hex bolts as
shown in Figure 13.
9. Check belt finger clearance:
• Engage attachment clutch lever and make sure belt
finger located opposite belt idler is less than 1/8"
(3.2 mm) from belt, but not touching the belt.
• If needed, adjust clearance by loosening hex bolts,
repositioning belt finger, and tightening bolts.
10. Reinstall belt cover and tighten hardware.
11. Adjust attachment clutch / brake. Refer to Operator’s
Manual for adjustment procedure.
12. Adjust traction drive clutch. Refer to Operator’s
Manual for adjustment procedure.
13. Fill fuel tank and reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
TRACTION DRIVE CABLE
REPLACEMENT
Remove Traction Drive Cable
NOTICE: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Place unit in service position. See Service Position on
page 8.
4. Remove bottom cover. See Bottom Cover Removal on
page 9.
See Figure 36.
5. Remove hairpin and flat steel washer securing cable
eyelet to swing gate and remove cable.
WARNING: AVOID INJURY. Auger / impeller
must stop within 5 seconds when attachment
clutch lever is released.
WARNING: AVOID INJURY. Before placing unit
in service position, close fuel valve and drain fuel
from tank and fuel system. See Draining Fuel
System on page 8. Make sure unit is secure and
will not tip.
Figure 36
1. Hairpin
2. Flat Steel Washer
3. Cable Eyelet
4. Swing Gate
1
4
3
2