Operator`s manual

EN – 18
7. Reinstall left flange bearing and secure with three
tapping screws.
8. Reinstall spring clip into hex shaft.
9. Reinstall adjustment pivot pin into speed selector arm
and secure with hairpin.
10. Reinstall bottom cover and secure with six hex bolts.
11. Reinstall wheels and secure with axle lock pins.
12. Return unit to operating position.
13. Fill fuel tank and reconnect spark plug wire.
14. Adjust speed selector lever. Refer to Operator’s
Manual for adjustment procedure.
AUGER REPLACEMENT
Remove Auger
NOTICE: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Separate auger housing from frame. See Separate
Auger Housing from Frame on page 10.
See Figure 25.
4. Remove hardware securing attachment drive pulley
assembly to auger housing and remove pulley
assembly.
5. Loosen, but DO NOT remove hardware securing
bearing plate to housing.
Figure 24
1. Shift Fork
2. Flat Steel Washer
3. Pinion Gear
4. Spur Gear
1
2
3
4
2
Figure 25
1. Hex Bolt
2. Locking Washer
3. Attachment Drive Pulley
4. Bearing Plate
1
4
3
2