Operator`s manual

EN – 17
See Figure 21.
6. Remove spring clip from right side of hex shaft.
7. Remove hardware securing left flange bearing to
frame and remove flange bearing.
See Figure 22.
8. Slide hex shaft left and remove pinion gear and flat
steel washer from hex shaft.
9. Continue sliding hex shaft left and remove friction disc
assembly from unit.
See Figure 23.
10. Remove hardware securing friction disc to drive
carrier and remove friction disc.
Install Friction Disc
1. Install new friction disc to drive carrier with cup side
positioned toward drive carrier.
2. Secure friction disc to drive carrier with three tapping
screws. Torque to 5 – 6 lbf-ft (7 – 8 N•m).
See Figure 24.
3. Reinstall friction disc assembly into shift fork. Make
sure washers on assembly are positioned against shift
fork as shown.
4. Reinstall hex shaft through frame and friction disc
assembly.
5. Reinstall pinion gear and flat steel washer onto hex
shaft.
6. Align pinion gear with spur gear and insert hex shaft
into frame and flange bearing.
Figure 21
1. Flange Bearing
2. Hex Shaft
3. Spring Clip
4. Tapping Screw
1
2
3
4
Figure 22
1. Friction Disc Assembly
2. Hex Shaft
3. Pinion Gear
4. Flat Steel Washer
1
2
34
Figure 23
1. Friction Disc
2. Drive Carrier
3. Tapping Screw
1
2
3