Operator`s manual

EN – 14
Install Traction Drive Belt
See Figure 15.
1. Install belt onto traction drive pulley.
2. Install belt onto traction sheave.
3. Move swing gate so swing gate tab aligns with stop
hole in frame.
IMPORTANT: Make sure support bushing is correctly
seated in frame and is flush with frame.
4. Slide swing gate right so top of swing gate inserts
through support bushing and swing gate tab inserts
through stop hole.
IMPORTANT: Make sure pivot bushing is correctly seated
in frame and is flush with frame.
5. Reinstall swing gate spacer.
6. Align pivot bushing holes with holes in frame and
swing gate spacer. Secure with two tapping screws.
7. Reconnect idler spring to traction drive idler.
8. Reconnect swing gate return spring to frame.
9. Reinstall attachment drive belt. See Install Attachment
Drive Belt on page 12.
10. Adjust traction drive clutch. Refer to Operator’s
Manual for adjustment procedure.
11. Reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
Figure 15
1. Traction Drive Pulley
2. Traction Drive Belt
3. Traction Sheave
4. Support Bushing
5. Swing Gate Tab & Stop Hole
6. Pivot Bushing
7. Idler Spring
8. Traction Drive Idler
1
2
3
6
4
5
8
7