Product Manual
Table Of Contents
- DH2000 CORDLESS HEDGE TRIMMER (w/ battery and charger) DH2000W CORDLESS HEDGE TRIMMER (w/o battery and charger)
- Table of Contents
- Introduction
- Servicing Information
- Safety
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Disposal
- Specifications
- Warranty Statements
- Product Registration
- Notes
28 X7508170201
© 03/2016 ECHO Inc.
TROUBLESHOOTING DH2000
TROUBLESHOOTING
Read, understand, and follow all safety and operating instructions in this manual.
Trouble Cause Remedy
Red Charger light flashes or does not
light up
-Plug not connected to power outlet -Plug in the charger
-Battery pack not installed properly -Check the battery pack installation
-Obstructed connection -Reinstall battery pack again after
removing obstructions from connection.
-Fault in the charger -Ask your Shindaiwa dealer
-Fault in the battery pack -Ask your Shindaiwa dealer
Unit will not turn on -Battery pack not installed properly -Check the battery pack installation
Unit does not run when turned on -Battery pack discharged -Charge the battery pack
-Blades head obstructed -Turn off the unit remove battery and
clean obstruction from blades
-Battery pack outside acceptable
temperature range
-Remove the battery pack and allow to
cool
-Seized blades Brush loose debris from blades and
lubricate
Running time is too short -Battery pack outside acceptable
temperature range
-Remove the battery pack and allow to
cool
-Unit electronics too hot -Turn unit off and allow to cool
-Battery pack discharged -Charge the battery pack
Damaged blades -Ask your Shindaiwa dealer
Unit vibrates excessively -Fault in internal parts -Ask your Shindaiwa dealer