Log Splitter Owner/Operator Manual Manuel Du Propriétaire/Utilisateur Manual del propietario/operador Models 917001 – 27-Ton Log Splitter 917002 – 34-Ton Log Splitter ENGLISH FRANÇAIS ESPAÑOL 03860300E 8/10 Printed in USA
TABLE OF CONTENTS SAFETY. . . . . . . . . . . . . . . . . . . . . . . . . . 4 TROUBLESHOOTING . . . . . . . . . . . . . 20 ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . 8 SERVICE PARTS . . . . . . . . . . . . . . . . . 21 CONTROLS AND FEATURES . . . . . . . 10 ACCESSORIES. . . . . . . . . . . . . . . . . . . 21 OPERATION . . . . . . . . . . . . . . . . . . . . . 11 SPECIFICATIONS . . . . . . . . . . . . . . . . . 21 MAINTENANCE SCHEDULE . . . . . . . . 17 WARRANTY . . . . . . . . . . . . .
PRODUCT REGISTRATION The Ariens dealer must register the product at the time of purchase. Registering the product will help the company process warranty claims or contact you with the latest service information. All claims meeting requirements during the limited warranty period will be honored, whether or not the product registration card is returned. Keep a proof of purchase if you do not register your unit.
SAFETY NOTATIONS NOTE: General reference information for proper operation and maintenance practices. IMPORTANT: Specific procedures or information required to prevent damage to unit or attachment. WARNING: This splitting machine is capable of crushing or amputating body parts. Failure to observe the safety instructions in the manuals and on decals could result in serious injury or death. Tragic accidents can occur if the operator is not alert to the presence of children.
4. WARNING! Keep hands away from moving parts. Moving parts can crush or cut. OL0480 Operate the log splitter on level surfaces. Stay off slopes and slippery surfaces. No smoking, No sparks, No flames. Never fill fuel tank when engine is running, hot or unit is indoors. Never overfill fuel tank. Replace fuel cap securely and clean up spilled fuel. OL0710 5. DANGER! Always wear eye and hearing protection. Hold logs on sides when loading.
OPERATOR ZONE This unit is designed to be operated by one person located in the operator zone (see figure 3). Horizontal Operating Position Operator Zone Operator Zone Vertical Operating Position Operator Zone Figure 3 SAFETY RULES If unit is to be used by someone other than original purchaser; loaned, rented or sold, ALWAYS provide this manual and any needed safety training before operation.
Do not move the unit up or down a hill by hand. Use a tow vehicle with suitable braking system. Use extra care when towing unit. DO NOT exceed 45 mph (72.4 kph). Safety chains MUST be attached to vehicle when towing unit. NEVER allow anyone to ride on the unit. NEVER transport cargo on the log splitter Check local, state and federal laws before towing. Any modifications required to meet these laws are the responsibility of the purchaser.
Position logs against end plate grips before operating hydraulic cylinder. Split logs end to end in the direction of the grain, not against the grain. Keep fingers and hands away from cracks in logs while splitting. These can quickly close and pinch or crush body parts. On logs that are not square place the longest portion of the log closest to the beam and the most square end against the splitter wedge. Use only your hand to operate the control lever. ASSEMBLY Tongue Assembly WARNING: AVOID INJURY.
Check Tire Pressure Secure with hex bolts and nuts. CAUTION: Avoid injury! Explosive separation of tire and rim parts is possible when they are serviced incorrectly: • Do not attempt to mount a tire without the proper equipment and experience to perform the job. • Do not inflate the tires above the recommended pressure. • Do not weld or heat a wheel and tire assembly. Heat can cause an increase in air pressure resulting in an explosion. Welding can structurally weaken or deform the wheel.
CONTROLS AND FEATURES 17 1 2 3 16 5 6 14 13 8 19 4 15 11 20 7 9 10 12 18 Figure 7 1. Control Lever 2. Splitter Wedge 3. End Plate/Grip 4. Beam 5. Hydraulic Cylinder 6. Stripper Plate 7. Oil Drain Plug 8. Fuel Tank/Filler 9. Recoil Starter 10. Front Jack Stand 11. Hitch Coupler – 2-In. Ball 12. Safety Chains 13. Rear Stabilizer 14. Hydraulic Pump 15. Hydraulic Tank 16. Hydraulic Tank Dipstick/Breather 17. Beam Assembly Lock 18. Hydraulic Oil Filter 19. Engine Switch 20.
OPERATION CONTROLS AND FEATURES The fuel shut-off valve has two positions: Closed Position: Use this position to service, transport, or store the unit. WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding. See figure 7 for all controls and features locations. Open Position: Use this position to run the unit. Engine Switch 1 2 The engine switch has two positions: 1. OFF – Engine will not start or run. 2. ON – Engine will start and run.
Out/Down (1) – Move lever in this direction to extend cylinder toward end plate. Keep pressure on lever until log is split. Lever does not lock in this position. Release as soon as log is split or cylinder is fully extended. NOTE: Splitter wedge is designed to reach full extension and stop between 1 and 2" (25 and 50 mm) before contacting end plate. IMPORTANT: When cylinder is fully extended do not hold lever in out position. Pump damage will result.
3. Continue to retract the cylinder until the log is dislodged from the splitter wedge. 4. Once removed from the splitter wedge rotate log and split from a different location or split log from the other end. CAUTION: Do not use the unit if the stripper plates are bent or damaged. Bent or damaged stripper plates must be repaired or replaced before use. 917001 Notch Front Jack Stand Remove hair pin and clevis pin and rotate jack stand up or down.
917002 HeightAdjustment Handle Transport Position Remove hair pin and slide lock pin out. Pull out lock handle and rotate jack stand up or down. Work Position Insert lock pin through brackets and insert hair pin. Release handle to lock in place. Figure 14 Figure 15 Rear Stabilizer OPERATION (Figure 15) Rear stabilizer must be positioned down and locked in place when operating in the horizontal position. 1. Remove hair pin from upper lock pin and slide lock pin out from brackets. 2.
4. Set the choke lever based on engine temperature (see Choke Control Lever on page 11). 5. Slowly pull the recoil starter until engine compression makes pulling difficult. Let the starter rewind a little, and then pull smoothly and quickly to start the engine. 6. Repeat step 5 as needed. 7. Fully open the choke and set the throttle to full fast before operating the unit. CAUTION: Avoid damage or injury! Use maximum caution when towing log splitter: • DO NOT exceed 45 mph (72.4 kph).
FOR BEST PERFORMANCE Splitting Logs • WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding. • • Determine if the size of the logs to be split can be safely and comfortably lifted up onto the beam in the horizontal position. If logs are too heavy for the operator, position the beam in the vertical position for splitting. CAUTION: During operation, engine and hydraulic system are hot. Always stop engine and allow unit to cool before changing beam positions.
MAINTENANCE SCHEDULE WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding. IMPORTANT: Proper maintenance can prolong the life of unit. The following chart shows the recommended service schedule. Interval Task Action Each Use Clean Unit Clean engine and hydraulic tank of all dirt and debris. DO NOT spray unit with water. Do not use solvents, hard cleaners, or abrasives. NOTE: Protect painted surfaces with automotive-type wax.
HYDRAULIC OIL SYSTEM Hydraulic Oil Reservoir Cap/Breather WARNING: HYDRAULIC FLUID can result in severe burns. Fluid in hydraulic system can penetrate skin and result in serious injury or death. Be sure to stop the engine and relieve hydraulic pressure before doing any work on hydraulic parts. Keep body and hands away from pin holes or nozzles which expel hydraulic fluid when under pressure. Use paper or cardboard, not hands, to search for leaks.
8. Spin new oil filter onto filter housing until it makes contact. Tighten oil filter another 1/2 turn. 9. Add new oil to the oil tank. 10. Check hydraulic oil level. 11. Properly dispose of waste oil. Purge Air From Hydraulic System 1. With the engine running, extend the hydraulic cylinder out fully and then retract fully. 2. Repeat 4 – 5 times. Erratic movement in the hydraulic cylinder indicates that there is air in the system. 3. Stop the engine and check the hydraulic oil level. Add if necessary. 4.
TROUBLESHOOTING PROBLEM Engine will not start. PROBABLE CAUSE CORRECTION 1. Engine switch in Off position. 1. Move switch to On position (see Engine Switch on page 11). 2. Fuel shut-off valve in Off position. 2. Move valve to On position (see Fuel ShutOff Valve on page 11). 3. Fuel tank empty. 3. Fill fuel tank with fuel (see Fill Engine Fuel Tank on page 9). 4. Spark plug disconnected. 4. Connect spark plug. 5. Faulty spark plug. 5. Replace spark plug. 6. Choke lever in wrong position. 6.
SERVICE PARTS ACCESSORIES See your authorized Ariens dealer for genuine OEM service parts. See your authorized Ariens dealer to add these optional accessories to your unit. Part No. Description Part No.
Two-Year Limited Lawn and Garden Warranty This warranty statement applies only to 21-Inch Walk Behind Lawn Mowers, Wide Area Walks, AMP Wide Area Walks, Tillers, String Trimmers, Log Splitters, Edgers and Power Brushes Ariens Company (Ariens) warrants to the original purchaser that Ariens and Gravely brand consumer products manufactured and sold by Ariens will be free from defects in material and workmanship for a period of two years after the date of purchase.
To find an Ariens or Gravely authorized service representative, contact Ariens at: 655 W. Ryan Street Brillion, WI 54110 (920) 756 - 2141 www.ariens.com www.gravely.com Exceptions and Limitations • Batteries are warranted only for a period of 12 months after date of purchase, on a prorated basis. For the first 90 days of the warranty period, a defective battery will be replaced free of charge.
Ariens Company 655 West Ryan Street Brillion, WI 54110-1072 920-756-2141 Fax 920-756-2407 www.ariens.
