Instructions / Assembly

ManualsBrandsAriel ManualsBath4 ft. 11 in. Whirlpool Tub in White

1. turn on the power and make sure it won't surpass the electric current.

2. Make sure to fix leakage protection device, and the socket must be connected

with earth line.

3. Please don't block the water recycle net by any part of your body, if that

occurs, turn off the pump or power at once.

4. A switch for the supply of the hot/cool water must be installed, when stop to

use this product. The water supply switch and the power source switch

should be turned off.

5. Check the water level if it is 10-20 mm above the spray nozzle before you

start the pump or the pump could be damaged.

6. Dispose of this product according to the local law when it is out of use.

7. Please contact the local dealer for help if you have any problem.

Air bubble pump

Bottom light

Ozone

Speaker

input of CD frequency

Antenna

Water probe

Input of control panel

Electric box

Heater

Water pump

The related connection will not be

connected if the unit without bubble

Your best choice!Your best choice!

Summary of content (4 pages)

PAGE 1
. turn on the power and make sure it won't surpass the electric current. 2. Make sure to fix leakage protection device, and the socket must be connected with earth line. 3. Please don't block the water recycle net by any part of your body, if that occurs, turn off the pump or power at once. 4. A switch for the supply of the hot/cool water must be installed, when stop to use this product. The water supply switch and the power source switch should be turned off. 5.
PAGE 2
Dear user: Thank you very much for purchasing our sanitary ware. To enable you to use this 1. The daily maintenance should be cleaned with ordinary detergent and soft product safely and effectively, please read this installation and operation cloth. Please do not use the detergent which contains acetone or ammonia manual carefully before use. liquid. If there marks or something like glue on the surface of bathtub, just polish it with soft cloth dipping with gas. 2.
PAGE 3
Plug Problems Reasons Maintenances Socket 1.check and reconnect the wiring system. 1. turn on the system 2.the impeller of water pump doesn't rotate 2. check through and remove the garbage not working. 3.water pump is broken which caused by 3. install a new water pump hydro-massage 2.air adjustment valve is abnormal working normally. cannot be adjusted 3.jets or nozzles are blocked 0 35 Shower Red pipe hot water pipe blue pipe cold water pipe 640 3.
PAGE 4
Heater Light TUN TUN O3 Vol + TUN TUN Light TV Vol - Vol+ Vol+ VolVol- Heat Heater /CD FM O3 TUN /CD FM TUN Press to start the air bubble pump , then the symbol will be shown on the screen . The bubble jets spurt out air bubble. Press again to turn off the bubble. ON/OFF ON/OFF The related buttons has no effect if the unit without bubble system, heat pump, bottom light installed. 1.The remote control is waterproof and dampproof. 2.