Installation Diagram

phenomenon
reason
how to solve
2. Normally, there should be
four and four shockproof
cushions to fix the motor.
Fasten the loosen screws.
1. The not is partly jammed.
2. The water level is too low;
3. The hydro-massage water regulating
switch is turned off .
4. Other reasons.
2. The fastening screw or the shockproof
glue of the motor are incomplete or loose;
3. The water level does not reach the
normal height.
4. There is something with wrong the motor.
The motor of the
massage bath tub
can not be started.
1. The voltage is abnormal or the power is
off;
2. The fuse is cut off the creepage switch
is off;
4. The pneumatic switch is broken.
Violent vibration
and too much
noise
The motor works
normally but no
water comes out
from the nozzles
or the water
pressure is not
high enough.
1.The steel stand under the bathtub is not
balanced. The screws are not fastened.
3.The pipe connecting the pneumatic switch
to the motor falls off or blows.
1.Put the bathtub flatly on the
floor and adjust the screws to
make the steel stand level.
Fasten the screws.
3.The normal height of the water
level should be 10cm higher
than the metal parts of the
nozzles.
14.Dismantle the net and clean
it to make the water flow
smooth.
15.Increase the water level to
normal height (10cm higher
than all the nozzles).
16.Turn on the hydro-massage
water regulating switch.
1. a)Turn on the power;b) Insert
the motor power plug into the
special socket;
4. Ask an electrician to replace
the pneumatic switch.
2.Ask a technician to check wh-
ether there is something wro-
ng. If nothing wrong replace
the fuse or turn on the creep-
age overload protector.
3.Get the plastic pipe connect-
ed or replace it.
1. Put off the drainer's stopper screw it or
adjust the screw to suitable position.
2. Replace the whole set.
3. Dismantle the drainer then adjust it to
be even reinstall it.
1. a).Replace the bulb;
b).Get the line connected.
c).Replace the transformer
2. Check the massage motor following
the process when the motor can not
be started.
phenomenon
reason
how to solve
The bottom lamp
does not work.
1. The water
pump works
but the lamp
doesn't
2. Neither the pump nor the lamp
works.
a). The bulb is broken
b).The connection line
breaks off
c).The transformer is
broken
The rubber ring in the valve is
distorted or worn out .
The cold and hot
water valve can
not be inlet turned
completely.
Replace it.
Replace it.
The magnetic core is worn out.
1. The screw is loosen or adjusted
too low;
2. The drainer's drawing cable is
broken.
3. The cushion is uneven.
The crystal han-
dwheel is loose.
The waterdistri-
bution pump can
not be turned
completely.
The drainer can
not jump up,or
leaks.
Press the screws on the top of the wheel
and screw them clockwise.
Trouble shooting