Installation Diagram

Maintenance
1.Temperature
The massage bathtub is suitable for water beow 80 C.When using it,turn
on the cold water before turning on the hot water.
2.Maintenance
Maintenance of plated parts: Please use flannelet to rub them gently. Don't
use rough cloth to rub them.
Maintenance of the bathtub body: When scratches appear, 1500 # sand
paper can be used to rub it. Then polish the tub by toothpaste and flannelet.
How to clean the net: Unscrew the net and remove it. Clean the net to make
the water flow smoothly. Do not use strongly corrosive chemical liquid (e.g. -
vitriol, muriatic acid or lye) to rub the net.
3.Installation:
First adjust the screws so that they reach the ground. Then make the bath-
tub level and fasten the screws. Fixing the four legs of the steel stand to red-
uce the vibration of pump. To prevent the pump or steel stand from transloc-
ation after long time use, rubber or some flexible material can be used as sh-
ockproof cushion. Seal the gap between the bathtub and the wall with glue.
Please note that the drainage tube can not be folded.
4.Prepare to use:
Please make the water level reach normal height (usually 10cm higher than
the nozzles), to prevent the pump from working without water. The direction
of the nozzles can be adjusted to your mind.
When installing the bathtub, please make sure the metal parts are well e-
arthed. The creepage overload protector should be installed in the power s-
upply wire.
5.Special notice:
Before connecting the water pipe to the water inlet valve of the bathtub, pl-
ease eliminate the impurities in the pipe such as rust. Take care not to dama-
ge the valve core.
6.Note: