Installation Guide
Hanging your Ariel Shower Panel
You can hang your shower panel on the mounting brackets you installed when you are done checking for leaks.
To hang the shower panel:
1. Put your shower panel on the wall surface with the mounting straps above the corresponding mounting
brackets while making sure that the exible supply lines are in the shower panel enclosure.
2. Slide the shower panel down. Stop when it rests on the mounting brackets you installed.
3. e shower panel must be seated onto the mounting brackets by pulling down on the shower panel.
You will have seated the unit on the mounting brackets properly aer you feel a slight movement down
ward and the shower panel stops moving.
4. Seal the shower panel with a caulk gun using a bathroom rated caulk or sealant. Run sealant where the
unit contacts the wall surface, using a bead of caulk.
5. Use excess caulk to ll in any cracks or spaces in the joint, and wipe away the excess caulk.
e Shower Wand and Hose Installation
1. ere are two tapered ends to the shower wand. One end has an O-ring around the outside. Install the
end with the O-ring onto the shower wand. Before screwing the hose and the wand together, install the
rubber gasket that came with your unit.
2. e other end of the hose (without the O-ring) will be installed onto the outlet spout for the shower
wand. A rubber gasket must be placed between the outlet spout and the hose.
3. e shower wand goes into the wand holder with the O-ring holding it in place.
Operating Your Ariel Shower Panel
IMPORTANT: You must read and understand all of the safety statements and warnings in this document
before operating your shower panel unit. Failure to do so may risk the warranty of your product. If you do not
understand this document, we ask that you contact the manufacturer or your dealer for assistance.
Diverter Valve
e ow of water to the overhead shower, shower wand, body jets and the ON/OFF position is controlled by
the diverter valve.
e diverter valve is operated by rotating it to one of the devices above depending on which one you want to
use. Aer rotating it to a device you will feel a click for each device.
IMPORTANT: e diverter can only operate one device at one time. Only one device can be operated at one
time because of current water conservation requirements and typical residential ow rates and water pres-
sure. For example, the body jets and overhead shower will not work at the same time.