User's Manual

ARIAKON SIM-5, SIM-5N .68 CALIBER PAINTBALL MARKER
DISASSEMBLY CONTINUED
Page 22
Diagram 1-11 Cocking Lever Disassembly
A B
A— Begin by unscrewing the Cocking Lever Screw with a flat or
‘—’ screwdriver. (part # 2).
** NOTE: TAKE A CLOSE LOOK IN THE SIGHT HOUSING IN
THE ORDER OF THE COCKING LEVER SPRING (part # 5),
THE COCKING ROD (part # 3), AND THE COCKING ROD
GUIDES (parts # 4&6) AND MAKE SURE YOU PLACE THESE
BACK IN THAT SAME ORDER.**
B— Pull them out towards the direction shown.
For re-assembly on any of the previous disassemblies shown
should be done in the exact reverse order of the instructions
provided. For added support we are providing these video clips
on our website at www.ariakon.com for you to download during
anytime of need. Again, Please pay special attention to all the
***asterisks*** noted.
IMPORTANT: Paintball approved eye and face
protection must be worn at all times when handling
this or any other marker. Always make sure that
when not actively firing the marker in a paintball
game that the marker is in ‘SAFE’ mode and the
barrel plug or barrel cover is properly inserted.
1) Ammo Box (Hopper):
Make sure that the feed port is clean to keep the paintballs
feeding properly and to help avoid breaking any paint. Also,
make sure there are no sharp edges or debris in your hopper.
Install the hopper into the feed. Now open the lid on the
hopper and fill with paintballs.
2) Air Source Installation:
First make sure the marker is in ‘SAFE’ mode. Next you need to
cock the marker by pulling the Cocking lever (part# 2) all the way
back until it clicks. To install the air source, insert the tank valve end
into the Air source adapter (part# 34). Twist the tank clockwise into
the marker until you hear and feel the tank ‘engage’, then give the
tank about 1/3 turn more so it does not become loose. Your marker
is ready to fire once you switch it from ‘SAFE’ mode to fire mode.
3) Adjusting the Velocity:
To adjust the velocity, use the velocity adjustment
screw (part # 29) on the rear of the marker directly under
the bolt. Turning the adjustor in or clockwise will increase the
velocity, and adjusting it out or counter-clockwise will lower
the velocity.
ARIAKON SIM-5, SIM-5N .68 CALIBER PAINTBALL MARKER
Page 7
GETTING STARTED