User's Manual

ARIAKON SIM-5, SIM-5N .68 CALIBER PAINTBALL MARKER
DISASSEMBLY CONTINUED
Page 18
B— Unscrew and Remove the Velocity Lug (part # 30) With a Flat or
‘—’ Screw driver
C— Pull out the Spring Guide Pin (part # 31), the Velocity Spring
(part # 32), and the Striker Cushion (part # 33) towards the direction
shown.
Diagram 1-4 Removing Marker Internals Continued...
B C
D E
D— Unscrew the Connector Pin Retaining Screw (part # 28) on the
back end of the bolt (part # 26) 3 turns with a 2mm Hex tool.
**NOTE: DO NOT REMOVE THIS SCREW**
E— Remove Connector Pin (part # 27) towards the direction shown.
F— Tilt upward and shake out both
the bolt and striker (parts # 26 and
34) **NOTE: YOU MAY HAVE TO
PUSH OUT THE STRIKER USING
A SCREWDRIVER OVER THE
TRIGGER ASSEMBLY.**
F
ARIAKON SIM-5, SIM-5N .68 CALIBER PAINTBALL MARKER
LAODING YOUR MARKER
Page 11
These are the basic steps in loading your marker correctly and safely.
Please follow the order of these directions every time you should use
this marker.
STEP 1: Loading your marker with a hopper.
**Make certain that your maker is in the ‘SAFE’ position.**
Start off by placing a elbow on your hopper. Shown on picture ‘A’
STEP 4: Place the tip of the air canister in the ASA or Air Source
Adapter (part# 35) and turn in a Clockwise fashion to screw the canister
in place as shown on picture ’C’. Once you feel the marker engage, turn
the canister clockwise 1/3 more to ensure that it will not become loose.
STEP 2: After the elbow has been
placed on the hopper secure it to
the marker feed (part# 10) Also
shown in picture ‘A’
A
Step 3: Loading your marker with your air source.
Start off by cocking you maker in the ‘LOAD’ or ‘COCKED’ position as
shown on picture ‘A’
Take the cocking lever (part # 2)
and slide back towards the
direction shown till you feel and
hear a ‘CLICK’
B
A
C