Manual

Page 2-10 Rev. 0040807014 1614
Operating and Installation Instructions
CONA
®
-control
4.5.1 AS-i / PROFIBUS gateway
Fig. 7
No. Designation
1Status LEDs
2 PROFIBUS connector
3 Digital display
4 If a "fault" is indicated, the number
of the faulty slave and the reason
for the fault are shown by a dot
5 Buttons for manual control
6 AS-i power supply
7AS-i circuit
NOTE !
- Never connect slaves or repeaters to the power supply cable (ASI PWR).
- Never connect AS-i power supplies or other masters to the AS-i connecting
cable.
Status LEDs Meaning / cause
power - The master is receiving sufficient power
Profibus - LED on: The gateway is assigned to a PROFIBUS master
- LED off: The gateway is not assigned to a PROFIBUS master
fault - If a "fault" is indicated, the number of the faulty slave and the
reason for the fault are shown by a dot
U AS-i - The AS-i circuit is receiving sufficient power
AS-i active - Normal operation (the LED blinks to indicate B slaves)
prg enable - Addresses can be programmed automatically
prj mode - The AS-i master is in configuring mode
i