User guide

Page 46 0040501004 5010
Operating and installation instructions
Thrust actuator ARI-PREMIO-Plus
9.2 LED encoding (from software version 2.1.7 and higher)
10.0 Dismantlement of thrust actuator
To dismantle the thrust actuator proceed as follows:
- Loosen hexagon nut on the hood, carefully remove hood.
- Disconnect all cables led into thrust actuator from outside and remove from thrust
actuator.
- Place hood on carefully from above and fix in place with hexagon nut.
- Loosen grub screw inside torsion safety feature; screw coupling out of torsion safety
feature.
- Loosen clamping bolts connecting the thrust actuator to the fitting.
- Remove thrust actuator from valve.
-
No initialisation run Green Red
Blockage
Green Red Orange
Y
in
control signal failure Green Red Yellow
ADV - outside the travel path
Green Red Orange Yellow
Position can not be achieved
Green Red Orange Blue
Full travel too low
Green Red Orange Yellow Blue
ATTENTION !
- The supply line for connecting up the thrust actuator must be in the dead state
i.e. disconnected while dismantlement work is being carried out. After being
disconnected, the mains power must be prevented from being switched back
on again accidentally.
- The system must be run down (depressurised state) as the valve cone is not
held without the thrust actuator and would thus be conducted by the system
pressure.
- Valve plug approximately in mid lift position - on no account supported inside a
seat!