Instruction Manual

3
HOW TO DRIVE
HOW TO FIX DRIFTING
HOW TO FRONT WHEELIE
2. Push the throttle backwards to pop a front wheelie
2
1. Accelerate forwards for 2 seconds.
1
2
HOW TO INSTALL BATTERIES
HOW TO CHARGE
1
2 3
1. Open the battery door with a screwdriver
(A). If used batteries are present, remove
these batteries from the unit by pulling up on
one end of each battery. DO NOT remove or
install batteries using sharp or metal tools.
2. Install new batteries as shown in the
polarity diagram (+/-) inside the battery
compartment.
3. Replace battery door securely. Check your
local laws and regulations for correct recycling
and/or battery disposal.
1. Turn the vehicle off. 2. Plug the small end of the charging cable
into the charging port.
3. Plug the charging cable into a 5V DC
computer outlet.
4. Charging LED indicates charging. Blinking for
charging and solid ON when fully charged.
1 2 3
4
NOTE: If your truck does not connect to the controller the first time, turn the truck off, turn the controller off and repeat
the HOW TO CONNECT CONTROLLER instructions.
CONTROLLER NOT CONNECTING
HOW TO CONNECT CONTROLLER
1. Turn on the vehicle and place it on a flat
surface.
2. Hold the controller near your truck, press
the power button and wait until power
light stops flashing.
3. You are ready to drive.
4. Use the remote control to drive.
1 2 3
A
2
NOTE: LED charging
indicator light is inside of
the chassis. Look through
the cooling vents to see it.