User`s manual

4Ch H.264 hardware codec
-Network DVR
(1) CHANNEL : Selects channel
(2) MODEL : Selects camera model (protocol type) per each channel
(3) PTZ ID : Selects PTZ ID (per each channel)
(4) BAUDRATE : Selects data transmission speed
(5) CMD DELAY : Selects command delay time
3) Mouse Setup
If you increase sensitivity, mouse cursor
moves fast.
MOUSE SETUP
SENSITIVITY 3
DEFAULT ESC
AUDIO SETUP
CHANNEL CH1
INPUT VOLUME 00
OUTPUT VOLUME 00
DEFAULT ESC
4) Audio Setup
If you select a channel, the audio of the selected
channel is recorded.
(1) CHANNEL : By selecting a channel, you can set
audio recording ON/OFF.
(2) INPUT VOLUME : Volume setup for microphone
(3) OUTPUT VOLUME : Volume setup for speaker
2) Pan/Tilt Setup
PAN/TILT SETUP
COMMAND SETUP
SPEED SETUP
ESC
COMMAND SETUP
CHANNEL
MODEL
PTZ ID
BAUDRATE
CMD DELAY
COMMAND
LENGTH
CODE
DEFAULT
01
PELCO-D
000
002400 BPS
1 MSEC
PAN/TILT STOP
16
00 00 00 00
00 00 00 00
00 00 00 00
00 00 00 00
ALL-DEFAULT ESC
PAN/TILT SETUP
PAN SPEED 7
TILT SPEED 7
ZOOM SPEED 7
DEFAULT ESC
Å PTZ Camera setup
Å PTZ Speed setup
CHAP. 5 Setup
5) Spot Setup
SWITCHING INTERVAL 01 SEC
ALARM POPUP ON
MOTION POPUP ON
EVENT POPUP DURATION 05 SEC
DEFAULT ESC
SPOT SETUP
39
If events (MOTION or ALARM) happen on several channels at the same time, channel No. 1 has the
first priority to pop up. For example, if events happen on channel No. 1, channel No. 2, and
channel No. 4 at the same time, channel No. 1 pops up. If the motion disappears on channel No. 1,
then channel No. 2 pops up for the time duration that you set. However, even though motion
happens on channel No. 1 again within the duration, channel No. 2 still displays. If motion on
channel No.1 keeps on going even after the duration, channel No. 1 pops up again.
※ EVENT POP-UP DURATION
(1) SWITCHING INTERVAL
Channel switching time (01 sec. ~ 99 sec.)
(2) ALARM POP-UP
When ALARM is detected, the image of channel
connected with Alarm sensor pops up.
Set ALARM detection pop-up (ON/OFF)
(3) MOTION POP-UP
Set MOTION detection pop-up (ON/OFF)