User`s manual

ManualsBrandsArgus ManualsComputer equipmentH.264

4Ch H.264 hardware codec

-Network DVR

C. Dynamic IP of PPPoE (DSL)

DVR doesn’t support DSL (PPPoE), user will need to set NETWORK with IP SHARE in order to

access DVR remotely. At this time, user will need to port forward on DVR. Please contact IP SHARE

Manufacturer if you need to know how to forward port.

Even though the user may have a Static/Dynamic IP, if you want to use another device (PC) through

IP SHARE, set NETWORK as follows

1) Verify if IP address is OK or not with PC before connecting DVR.

(The internet connection confirmation)

2) Connect Router (IP SHARE) to DSL modem as shown the followingpicture.

3) Set the Internet connection on Router (IP SHARE). (Refer to the Router Manual).

4) Verify if sub-group of network in Router is OK or not.

5) Connect DVR to Router.

6) DVR : MENU → LOG IN DVR → EXTERNAL DEVICE →TCP/IP SETUP → IP SETUP.

7) Set DHCP to AUTOMATIC and click IP DETECT.

8) Set DHCP to MANUAL

9) Verify if MAC ADDRESS starts from 00-0A-A2….

10) Set IP PORT, (50000 recommended )

11) Go out of MENU SETUP.

12) Forward port from Router (Refer to the next page).

13) Access DVR with external IP and Port (Port forwarded).

* If Router supports DDNS, user can access Remote Viewer using Domain Information.

* If user fails to access, please verify 1,4,7,8,12 again.

DSL Modem

(Dynamic IP)

Router or

Gateway

(IP Share)

DVR

(Server)

ISP

CHAP. 5 Setup

IP SETUP

MAC ADDRESS

DHCP MODE

IP PORT

IP ADDRESS

GATEWAY

SUBNET

00-0A-A2-**-**-**

AUTOMATIC

IP DETECT

50000

192.168.001.160

192.168.001.001

255.255.255.255

ESC