User`s manual

4Ch H.264 hardware codec
-Network DVR
28
MOTION SETUP
CHANNEL
CH1
SENSITIVITY
6
DURATION
05
SIZE
2
DEFAULT ALL-DEFAULT ESC
Blocked Area (RED)
(non-motion detection area)
Non-Blocked Area
(motion detection area)
4) Motion Setup
CHAP. 5 Setup
MOTION SETUP: You can change values by mouse wheel and left/right button of the mouse.
-SENSITIVITY: Adjust sensitivity of a movement. You can adjust level 1 ~ level 7.
[DEFAULT : 6]
- DURATION : Whenever motion is detected (set in Motion Recording mode),
DVR records for a certain time from the point when motion is detected.
(2 sec.~99 sec.) [DEFAULT : 5 sec.]
- SIZE : Select the CELL SIZE for Blocked Area (RED).
(1,2,3,6, and ALL) [DEFAULT : 2]
- ALL-DEFAULT: Default setup for all channels
MOTION MASK SETUP : Set motion detection area.
- CELL : Move to the cell and then decide to make it activated or deactivated by clicking it.
W
hen the cell is activated, motion is detected. Motion is not detected on
deactivated cells.
Whenever you click a cell, it changes between activated and deactivated.
BLOCK SETUP: First, you decide ‘Activated’ or ‘Deactivated’ by clicking a cell.
Then, if the initial cell is ‘Activated’, the blocks dragged by the mouse are
also activated.
If the initial cell you select is deactivated, the blocks dragged are also deactivated.