User`s manual

4Ch H.264 hardware codec
-Network DVR
12
CHAP. 4 Operation
4-1. System Log-In
4-2. HDD Clear & Factory Default
DVR LOG-IN
USER ID ADMIN
USER PW ________
1 2 3 4 5 6 7 8 9
ENTER EXIT
If the password entered matches previously set password, you can log into ‘MAIN MENU’. If
an incorrect password is entered, you will see “PW IS NOT CORRECT” message on display.
The factory default password is none. Just click ‘ENTER’ for first time initial log in.
-Factory default password
ADMIN : (Blank)
MANAGER : ‘1’
USER1~USER8 : ‘2’~’9’
※ For security reasons, be sure to make note of your own password.
※ The authority of MANAGER & USERS for changing critical settings of DVR is limited due to security reasons.
Before first operation, you must check that each channel is displaying properly and log in
‘Main Menu’ and set Time/Date and set HDD clear.
1) After power on, a right-click of the mouse
shows an icon bar on the screen. Then click
the [Menu] icon to log in.
2) Then, you will see ‘DVR Log-In’ message
shown at right.
3) You may log in as an ADMIN, MANAGER, or
USER1 ~ USER8.
4) Input your password (Max. 8 digits are
available for password) and click ‘ENTER’.
5) To exit, click ‘EXIT’ button.
Mouse buttons Functions
Mouse Wheel Increases or decreases setup value on the Menu mode
Right Decreases setup value on the Menu mode
Left
Increases setup value on the Menu mode
Execute all of the functions (clicking icons)
GENERAL USE OF MOUSE
* Please use a mouse pad for proper operation of the mouse.