Datasheet

7 Operation on a VDSL Access
ARGUS 141 63
<Edit> Open the MAC address for entry. Enter the address in
hexadecimal from the keypad and the softkeys
<A..F>
(e.g. to enter a “C” press the softkey three times or to enter
an “F” six times, then finish up by pressing
<OK> to confirm
your entry). 
Default setting: 00:00:00:00:00:00
Use the address. The new address is only saved tempo-
rarily and will not be available when the ARGUS is
switched on again.
VLAN Use 
VLAN:
Specifies whether or not VLAN should be used: yes, no.
Default setting: No
ID: Identifier for the VLAN to which the frame belongs. Every
VLAN is assigned a unique number, the VLAN ID. A
device, which belongs to the VLAN with the ID = 1, can
communicate with every other device in the same VLAN,
but not with a device in other VLANs (one with an ID other
than 1, i.e. 2).
Range: from 0 to 4095
Default: 0
Priority: User-priority information. An eight-level (3 bits) priority can
be assigned to each frame. In this manner, it is possible
e.g. to give priority to forwarding voice data, while HTTP
data will be handled as a lower priority.
Range: 0 to 7
Default: 0
PPP: PPP (Point- to-Point Protocol) settings
User name
Entry of the user name assigned (by the
network operator)

Use the keypad to enter the user name.
When the right softkey is pressed it
assumes a different meaning and thus
influences the entries made from the
keypad (letters or digits):

