Datasheet

11 ARGUS Settings - Device
ARGUS 141 123
11 ARGUS Settings - Device
The ARGUS can be configured to suit special requirements. The default (factory) settings
can be restored by selecting "Reset“(see page 126).
11.1 Trace / remote
The ARGUS remains active and passes the recorded data online directly to the connected
PC.
The ARGUS - Main menu








The default (preset) Trace mode will be
marked in the display with a .


If the ARGUS cannot send the data to the PC without errors, the “PC” LED will flash at 5 Hz
(5 times per sec).
Mark the desired Trace mode The
selected Trace mode will be
marked blue in the display.
Open the next higher menu without
making any changes.
Off Basically, the data will not be sent to the PC.
Defaults
Auto PC sync. All data will always be sent to the PC (“PC” LED will flash).
This setting remains active even after the ARGUS is
switched on again.
Manual PC sync. The data will be sent to the PC once (“PC” LED will flash).
When the ARGUS is switched off and then back on again,
Trace mode will be off.
Settings
Trace / remote
The marked Trace mode will be
activated as the default setting.
Off