User's Manual

Use Mac Address Use the MAC address of wireless card as the AP’s name. System default is
APX. (X is last number of Mac Address.)
Security Setting Authentication mode and encryption algorithm used by the AP. The system
default is no authentication and encryption.
No forwarding among
wireless clients
If there is no beacon among the wireless clients, they can’t share information
with each other. The system default is no forwarding.
Hide SSID Don’t display the AP name. The system default is to not hide the SSID.
Allow BW40 MHz Allow BW40 MHz capability.
Default Use system default values.
Cancel Cancel the any changes without saving.
Apply: Apply the any changes made. If using default values, it will be shown as in
below figure