User's Manual

Config Setting
User can set and display detailed Soft AP information in this dialog box.
Items Information
SSID
AP name of user type. The user also can select [Use Mac Address] to display
it. System default is SoftAP-XX (XX is last two numbers of MAC address).
Wireless Mode Select wireless mode. 2.4G and 5G are supported. System default is 2.4G.
( 802.11 B/G/N mix selection item only exists for B/G/N adapter )
Country Region Code The Country Region Code allows the user to
specify the available channel list
based on their country's regulations.
Beacon (ms)
The time span between two successive4 beacons. System default is 100 ms.
TX Power The transmitting power of Soft AP. System default is 100%.
Idle Time The allowed idle time before proceeding with the authentication. The def
ault
is 300.
Wireless Protection
The user can chose from Auto, on, and off. System default is auto. (802.11n
wireless cards don’t support wireless protection.)
a. Auto: STA will dynamically change according to the AP.
b. On: Always send frames with protection.
c. Off: Always send frames without protection.
Channel Select the AP’s operating channel manually. System default is channel 1.
TX Rate The transmitting rate. The default is auto. (802.11n wireless cards don’t
support TxRate.)
Note: The country code selection is for non-US model only and is not available to all US model. Per FCC
regulation, all WiFi product marketed in US must fixed to US operation channels only.