User's Manual

WPS
WPS Configuration: The primary goal of WiFi Protected Setup (WiFi Simple Configuration) is to
simplify the security setup and management of WiFi networks. This adapter supports the
configuration setup using PIN configuration method or PBC configuration method through an
internal or external Registrar.
Items Information
WPS AP List Display the information of surrounding APs with WPS IE from last scan result. List
information includes SSID, BSSID, Channel, ID (Device Password ID), and
Security-Enabled.
Rescan Click to rescan the wireless networks.
Information Display the information about WPS IE on the selected network. List information
includes Authentication Type, Encryption Type, Config Methods, Device Password ID,
Selected Registrar, State, Version, AP Setup Locked, UUID-E and RF Bands.
Pin Code 8-digit numbers. It is required to enter PIN
Code into Registrar using PIN method. Each
Network card has only one PIN Code of Enrollee. Click on the Renew button to renew
the PIN code.
Config Mode The station serving as an Enrollee or an external Registrar.
WPS Profile List Display all of credentials got from the Registrar. List information includes SSID, MAC
Address, Authentication and Encryption Type. If STA Enrollee, credentials are created
as soon as each WPS success. If STA Registrar, Utility creates a new credential with
WPA2-PSK/AES/64Hex-Key and doesn't change until next switching to STA Registrar.
Detail Information about Security and Key in the credential.
Connect Command to connect to the selected network inside credentials.
Rotate Command to connect to the next network inside credentials.
Disconnect Stop WPS action and disconnect this active link. And then select the last profile at the
Profile Page of Utility if exists. If there is an empty profile page, the driver wi
ll select any
non-security AP.
Delete
Delete an existing credential. And then select the next credential if exist. If there is an
empty credential, the driver will select any non-security AP.
PIN Start to add to Registrar using PIN configuration method. If STA Registrar, remember
that enter PIN Code read from your Enrollee before starting PIN.
PBC Start to add to AP using PBC configuration method.
WPS associate IE Send the association request with WPS IE during WPS setup. It is optional for STA.
WPS probe IE Send the probe request with WPS IE during WPS setup. It is optional for STA.
Progress Bar Display rate of progress from Start to Connected status.
Status Bar Display currently WPS Status.
Auto Starts to add to AP by using to select the AP automatically in PIN method.