User's Manual

3. PoE connection
1. Connect (POE) RJ45 Jack to CPE RJ45 Jack with good quality
Ethernet cable.
2. Connect (LAN) Jack to PC or Switch Hub LAN port.
3. Plug in the power adaptor to PoE DC jack.
4. CPE Connection
1. Open the CPE enclosure you will find one RJ45 Jacks two LEDs and
one reset button.
2. Connect the PoE cable to either LAN port.
3. To reset the CPE just press and hold the reset button for about 10
seconds and wait for 35 seconds to reboot the CPE.
Notice:
This CPE default operation mode is in Bridge mode. Please go to the
webpage and change the operation mode to other mode for your CPE.
5. CPE configuration
The WLAN Broadband Router is delivered with the following factory
default parameters on the Ethernet LAN interfaces.
Default IP Address: 10.10.10.254
Default IP subnet mask: 255.255.255.0
WEB login User Name: admin
WEB login Password: admin