User Manual

Wireless 802.11a CPE
User Manual
Page 7 of 36
2.1.1. Operation Mode
In this option, you can configure the operation mode which suitable for your environment. The default
setting is
WISP
. There have four modes is provided:
 Bridge: All Ethernet and wireless interfaces are bridged into a single bridge interface. When
Bridge mode is applied, there have some functions change in Internet Settings section. As
you can see in below, Internet Settings section only has “LAN”, “DHCP Client”, “VPN
Pass-through”, “DNS”, and “Advanced Routing” for Bridge Mode’s configuration.

Gateway:
The first Ethernet port is treated as WAN port. The other Ethernet ports and the
wireless interface are bridge together and are treated as LAN ports.

WISP: The wireless interface is treated as WAN port and the Ethernet ports are LAN ports.
After Ethernet Converter mode is applied, the WAN will change from Ethernet type to
wireless type. There will be five LAN ports and one wireless WAN port. User must configure
wireless encryption connection and set the necessary protocols.
 AP Client: The wireless client interface is treated as WAN port, and the wireless AP
interface and the Ethernet ports are LAN ports.