User Manual

Wireless 802.11a CPE
User Manual
Page 25 of 36
Protocol:
This is the protocol type that will be used with the Port that will be blocked.
Destination Port Range: The single port or port range that will be denied to access. If no port is
specified, all ports will be denied access.
Source Port Range: The single port or port range that will be denied access to the Internet. If no
port is specified, all ports will be denied access.
2.4.2. Port Forwarding
You may setup virtual servers to provide service on internet.
Virtual Server Setting: Enable/Disable the port forward.
IP Address: This is the port number on the WAN side that will be used to access the application.
You may define a single port or a range of ports. You can use a comma to add multiple ports or
port ranges.
Port Range: This is the port used to forward the application. It can be either a single port or a
range of ports. For the TCP and UDP services enter the beginning of the range of port numbers
used by the service. If the service uses a single port number, enter it in both the start and finish
fields.
Protocol: Select the protocol (TCP, UDP, or TCP & UDP) used to the remote system or service.
Comment:
You may key in a description for the IP address.