User Manual

Wireless 802.11a CPE
User Manual
Page 22 of 36
[Add a routing rule]
Destination: Defines the base IP address (Network Number) that will be compared with the
destination IP address (after an AND with NetMask) to see if this is the target route.
Range: select the range from drop down list
Gateway:
Enter IP address of the next hop router that will be used to route traffic for this route If
this route is local (defines the locally connected hosts and Type = Host) then this IP address
MUST be the IP Address of the router.
Interface: Select the interface mode from drop down list.
Comment: Enter the comment for this static route.
[Current Routing table in the system]
To see the detail settings of current routing table in the system.
[Dynamic Routing Setting]
RIP: RIP can be used to cache routes learned by routing protocols, thus allowing the automation
of static routing maintenance. The router, using the RIP (Routing Information Protocol) protocol,
determines the network packet’s route based on the fewest number of hops between the source
and the destination. In this case, you could automatically adjust to physical changes in the
network layout. Default is Disable.